Tuesday, 20 September 2011

Installation Guide (Petrol engine)& (Diesel engine) How to apply Nano Fuel


Installation Guide (Petrol engine) How to apply Nano Fuel?

Locate the fuel line going to the engine (in between fuel filter and fuel injector). If there is an extra outer later on the fuel line, remove it. otherwise, wipe clean the fuel line with damp cloth. Then, put Qmax Nano Fuel (up to 8 pieces) on the fuel line, as close to the engine as possible by wrapping it tightly around the fuel pipe.
Installation Guide (Diesel engine) How to apply Nano Hose?
Locate the diesel supply hose in between Fuel filter and High pressure pump(or Diesel fuel pump). Replace the it with Qmax Hose (Do Not cut it short). Use the manual pump found at Fuel filter and pump it for ½ minute. Start engine as usual.
Also, if further improvement is desired, each fuel line can applied with a Nano Fuel. Refer to the diagram on right.
*installation on common-rail engine may be different
Others Application Nano Fuel (can also be clamp on)
 

- Brake hose (increase braking system, prolong brake fluid and components life)
- Air-cond hose (improve cooling efficiency, extend gas/oil life, reduce engine load, lesser noise & vibration)
- Water Radiator hose (reduce water temperature)
- Auto-gear Transmission hose(smoother gear shifting, extend ATF life)
- Audio amplifier power / RCA cable (improved sound performance)
- Spark Plug Coil wire(Greater engine responsiveness)

What is difference between Qmax Nano Fuel compare to others brand?

 Qmax Nano Fuel
 Ordinary
- NanoTechnology with far infra red device- Magnet based with magnetic fields device
- will not interference with
  electronic or electrical system
- Interference with electronic or electrical
  circuit (Distortion)-magnetic fields  
- Break fuel molecules into smaller- Arrange fuel molecules orderly
(fuel
 molecules size remain same)
- Almost complete combustion, more power,
  fuel saving and reduce carbon deposit  
- Poor combustion, ordinary power, same
  fuel 
consumption  and carbon deposit remains
- Works at high temperature (up to 105 °C)- Works at average temperature only (about 60 °C)
- Warranty up to 250,000 Km (or 5 years)- Warranty for 1 year
- Light weight (clamp to fuel hose)- Heavy weight (clamp to fuel hose)

1 comment:

  1. Great post, a very informative post along with pictures makes things much more clear and easier to understand.
    Fuel hoses

    ReplyDelete